killed steel的例句大全

Fully-killed steel has a low yield of goodsteel.

所以,镇静钢成材率较低.

I suppose semi-killed steel must be just between these two in every aspects.

我想半镇静钢可能在各方面都介于这两者之间吧?

The surface defects control of low carbon aluminium-killed steel

低碳铝镇静钢表面缺陷控制

Estimation of residual aluminum in killed steel during the continuous casting;

连铸铝镇静钢余铝量的估计；

All material used for pressure parts shall be killed steel.

压力部件所有的所有材料均应为脱氧钢。

Study on Improving Mechanical Performance of Low Carbon Aluminium Killed Steel

提高低碳铝镇静钢力学性能的研究

Owing to its excellent deep stamping and no-aging performances, IF steel becomes a new generation of stamping steel following boiling steel and aluminium killed steel and represents the development level of steel sheets for automobiles in a country.

近几年来，由于IF钢具有优良的深冲性和无时效性，已逐渐成为继沸腾钢和铝镇静钢之后的新一代冲压用钢，是一个国家汽车用钢板生产水平的标志。

What do the terms" rimming steel", "fully killed steel" and "semi-killed steel" refer to?

这3个术语“沸腾钢”、“镇静钢”、“半镇静钢”指的是什么？

This paper describes the method of production of semi-killed steel in Wuhan Iron and Steel Company, the grades made, and the results of using them.

本文概述了武汉钢铁公司半镇静钢生产的品种、工艺、质量及使用效果。

Mechanism on clogging of ladle nozzle during changing aluminum to silicon killed steel casting and its preventive measures

铝改硅镇静钢浇注钢包水口堵塞原因及预防措施

On Saturday, police killed at least two rubber farmers and injured 13 others during a riot in Yunnan province close to the border with Burma in which about 500 farmers attacked police with knives and steel bars, according to state media reports.

上周六，在云南省靠近缅甸边境的地方发生了一起骚乱。据国有媒体报道，约500名胶农手持刀具和钢管袭击警察，冲突中警察杀死了至少2名胶农，另有13人受伤。

Oxygen activity determination and control in free cutting semi-killed steel

半镇静易切削钢中氧活度的测定与控制

The effect of the finishing temperature and finishing pass reduction on the texture and drawability of hof rolled plate of semi-killed steel is studied with an analysis of ODF and inverse pole figure.

通过对半镇静钢气瓶用热轧钢板的三维取向分布函数（ODF）的测试与其反极图的分析，研究厂终轧温度和终轧道次变形量对HP255b热轧板织构和深冲性能的影响。

According to studies carried out in the plant, the percentage of bloom-crop end increased with an increase of Si content. The Si content of semi-killed steel B, b should be controlled below 0.07%.

根据大量的生产研究，认为半镇静钢随着[Si]含量的提高，钢坯切头率增加，B5b半镇静钢的适宜硅含量，应控制在0.07%以下。

Comparison tests were carried out to determine the surface and interior quality of semi-killed steel, and it was found that the "porosity" that the appeared on the cross section of the bloom could be left uncut, so that the metal yield could be increased.

对半镇静钢的表面和内部质量，进行了生产对比试验，认为因疏松引起的钢坯断面空洞，可以少切或不切，以便合理提高钢坯收得率。